Hmm. I planned to upgrade it to newest available IOS for this device, 15.0.2-SE11.
What kind of bricking are we talking about here? (Permanent or fixable)
I only found this:
A Catalyst 2960 with 64Mb of DRAM might display Low memory on the console
after upgrading to 12.2(58)SE or later
Which should be fixed, and if not, I could just downgrade it back. Worst case scenario: I’ll have to use xmodem instead of TFTP.
I can’t remember the exact message, basically when we upgraded about 10 of ours, they wouldn’t let us make any config changes past a certain point because they saw themselves as non genuine even though they are
we’ve recently replaced all of our switching, I’ll boot one of them up once I get in and check for you (+IOS version)
don’t update the firmware!!! these have a bug with their security module which essentially bricks them if you update past a certain point
Hmm. I planned to upgrade it to newest available IOS for this device, 15.0.2-SE11.
What kind of bricking are we talking about here? (Permanent or fixable)
I only found this:
Which should be fixed, and if not, I could just downgrade it back. Worst case scenario: I’ll have to use xmodem instead of TFTP.
I can’t remember the exact message, basically when we upgraded about 10 of ours, they wouldn’t let us make any config changes past a certain point because they saw themselves as non genuine even though they are we’ve recently replaced all of our switching, I’ll boot one of them up once I get in and check for you (+IOS version)